This module consists of a 5mm RGB LED and three150 limiting resistorsto prevent burnout. Adjusting the PWM signal on each colour pin will result in different colours. This is a DIP 3 Color LED Module. Through the PWM adjusting, three primary colours can be mixed to obtain different colours.
Connect the red pin (R) on the KY-016 to pin 11 on the Arduino. Blue (B) to pin 10, green (G) to pin 9 and ground (-) to GND. Notice that you do not need to use limiting resistors since they are already included on the board.
Connection Diagram:
Pin Connection with Arduino:
| LED module | Arduino |
| R | Pin11 |
| B | Pin 10 |
| G | Pin 9 |
| – | GND |
Features :-
- The use of plug-in full-colour LED.
- RGB trichromatic limiting resistor to prevent burnout.
- With a variety of single-chip interface.
- Through the PWM adjusting, three primary colours can be mixed to obtain different colours
- The working voltage: 5V
Specifications :-
| Operating Voltage (VDC) | 5 |
| LED Type and Size | RGB 5 mm |
| LED drive mode | Common Cathode Driver |
| PCB Width | 1.5mm |
| Length (mm) | 20 |
| Width (mm) | 15 |
| Height (mm) | 15 |
| Weight (gm) | 5 |
* product image for illustration purposes only. actual product may vary.
There are no reviews yet.