ATMEGA64A – AU Microcontroller – (SMD TQFP Package) – 8-Bit 64 Pin 64KB Flash Microcontroller

The ATMEGA64A is a low-power CMOS 8-bit microcontroller based on the AVR® enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATMEGA64A achieves through puts close to 1MIPS per MHz. This empowers system designer to optimize the device for power consumption versus processing speed.

Features:-

• High-performance, Low-power Atmel AVR 8-bit Microcontroller

• Advanced RISC Architecture

– 131 powerful instructions – most single clock cycle execution

– 32 × 8 General Purpose Working Registers + Peripheral Control Registers

– Fully Static Operation

– Up to 16MIPS Throughput at 16MHz

– On-chip 2-cycle Multiplier

• High Endurance Non-volatile Memory segments

– 64Kbytes of In-System Self-programmable Flash program memory

– 2Kbytes EEPROM

– 4Kbytes Internal SRAM

– Write/erase cycles: 10,000 flash/100,000 EEPROM

– Data retention: 20 years at 85°C/100 years at 25°C(1)

– Optional Boot Code Section with Independent Lock Bits

• In-System Programming by On-chip Boot Program

• True Read-While-Write Operation

–  Programming Lock for Software Security

• JTAG (IEEE std. 1149.1 Compliant) Interface

– Boundary-scan Capabilities According to the JTAG Standard

– Extensive On-chip Debug Support

– Programming of Flash, EEPROM, Fuses, and Lock Bits through the JTAG Interface

• Peripheral Features

– Two 8-bit Timer/Counters with separate prescaler and compare mode

– Two Expanded 16-bit Timer/Counters with Separate Prescaler, Compare Mode and Capture Mode

– Real Time Counter with Separate Oscillator

– Two 8-bit PWM Channels

– 8-channel, 10-bit ADC

• 8 Single-ended Channels

• 7 Differential Channels

• 2 Differential Channels with Programmable Gain at 1x, 10x, or 200x

– Two Programmable serial USART

– Master/Slave SPI Serial Interface

– Programmable Watchdog Timer with On-chip Oscillator

– On-chip Analog Comparator

– Byte Oriented 2-wire Serial Interface

• Special Microcontroller Features

– Power-on Reset and Programmable Brown-out Detection

– Internal Calibrated RC Oscillator

– External and Internal Interrupt Sources

– Six Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby, and  Extended Standby ‘

• I/O and Packages

̶  53 Programmable I/O Lines

̶  64-lead TQFP and 64-pad QFN/MLF

• Operating voltage

– 2.7 – 5.5V

• Speed Grades

– 0 – 16MHz

specifications:-

Program Memory                                               Type Flash
Program Memory Size (KB)                                64
CPU Speed (MIPS/DMIPS)                                 16
SRAM (B)                                                            4,096
Data EEPROM/HEF (bytes)                                 2048
Digital Communication Peripherals                   2-UART, 1-SPI, 1-I2C
Capture/Compare/PWM Peripherals                 2 Input Capture, 2 CCP, 8PWM
Timers                                                                2 x 8-bit, 4 x 16-bit
Number of Comparators                                   1
Temperature Range (°C)                                   -40 to 85
Operating Voltage Range (V)                           2.7 to 5.5
Pin Count                                                          64

* product image for illustration purposes only. actual product may vary.