MCP2515 CAN Bus Module with TJA1050 Transreceiver

This is a easy to use CAN bus module controlled via SPI Interface. It contains CAN Controller MCP2515 and TJA1050 which is a high speed CAN trans-receiver. This module can be esaily interfaced to any microcontroller via SPI Interface. It can also be interfaced to Arduino and Raspberry PI.

• Support CAN V2.0B technical standard, communication rate 1Mb/S.
• Use High-speed CAN transceiver TJA1050
• Dimension: 40×28mm
• SPI control for expand Multi CAN bus interface
• 8MHZ crystal oscillator
• 120Ω terminal resistance
• Module 5V DC power supply.
• 0 to 8 bytes long data field.
• Impedance matching, guaranteed drive capability, long-distance data transmission, prevent signal radiation
• The working current: typical 5mA, standby current 1 microamp. Except for the power indicator.
• Use serial port could view the communication data
• With the independent key, LED indicator, Power indicator
• With power pin
• Standard frames, extended frames, and remote frames.
• Positioning screw hole center spacing 23 mm x 38 mm

• VCC :5V power input pin
• GND : power ground pin
• CS : SPI SLAVE select pin (Active low)
• SO : SPI master input slave output lead
• SI : SPI master output slave input lead
• SCLK: SPI clock pin
• INT: MCP2515 interrupt pin

* product image for illustration purposes only. actual product may vary.